Creality’s new Ender 3 printer is AMAZING! Here is a skeleton done with the stock .4mm nozzle (our previous Prusa prints were done with a .25mm nozzle.) This is straight off the bed, no cleanup. .4 nozzle, .1 layer height, Hatchbox gray at 185 temp. 53 minutes to print. We haven’t even dialed the slicer profile in yet! You can get this amazing printer for $239 from Amazon (affiliate link below) or as low as $190 direct from China. We are working on a video review of this machine complete with build tips that will be posted soon.
Ender 3:
Bowden Tube fittings (not essential to begin with, but these are much better than the ones supplied with the printer and you will want to replace them eventually):
Extra nozzles:
Micro SD to SD extender:
Filament (eSun PLA Pro Gray):
***************************************************************************
Free Ender 3 mods from Thingiverse:
Cooling fan duct:
https://www.thingiverse.com/thing:3000563
Cable chain:
https://www.thingiverse.com/thing:2920060
Filament guide (top):
https://www.thingiverse.com/thing:2917932
Filament guide (lower):
https://www.thingiverse.com/thing:2886192
Electronics cover (this requires additional screws):
https://www.thingiverse.com/thing:2858209
Fan cover:
https://www.thingiverse.com/thing:2935204
Cable clips:
https://www.thingiverse.com/thing:2960375
Micro SD extender cover: